2019 Jeep Cherokee

On September 14, 2025, while driving on the highway, the vehicle began shaking violently, the check engine light illuminated and began flashing, and the vehicle progressively lost power and became undriveable. The vehicle had to be towed. No warning lights appeared prior to the incident. This failure follows a documented history of Power Transfer Unit (PTU) issues. In May 2024 at approximately 88,000 miles, diagnostic codes including C14A7-97 (PTU Motor - Component/System Blocked) were retrieved at an independent service center. The 4-wheel drive system was found to be stuck engaged. The transfer case actuator motor was replaced in December 2024 at approximately 93,000 miles by the same shop at my expense. The vehicle is a single-speed PTU configuration and was excluded from Equipment Safety Recall 02C (Two Speed PTU Failure), despite experiencing substantially similar symptoms: loss of drive power, vibration, and drivetrain malfunction. The PTU and transfer case are available for inspection. The failure has been confirmed by an independent service center. Prior to the highway failure, the vehicle exhibited difficulty accelerating, particularly at highway speeds, and an audible whirring sound from the drivetrain. It also jerked forward when shifting into Park. Safety was put at risk due to sudden loss of motive power at highway speed.

Put transfer case

The contact owns a 2019 Jeep Cherokee. The contact stated that upon starting the vehicle, the rearview camera display flickered with black and white streaks. The contact stated that upon shifting into reverse (R), the black and white streaks remained on the display, and the air conditioning controls were inoperable. The vehicle was taken to a dealer, where the contact was informed that the failure was a common issue. The manufacturer was notified of the failure. The failure mileage was approximately 47,000.

The contact owns a 2019 Jeep Cherokee. The contact stated that the "Service 4WD" message displayed. While attempting to reverse out of a parking space, the gear shifter shifted to neutral(N), and the message "Still May Move When in Park" was displayed. The contact shifted the vehicle back into park(P) and turned off the vehicle, and there was an abnormal boom coming from the vehicle. The contact restarted the vehicle, and the vehicle resumed normal operation; however, the failure reoccurred the next day. Upon investigation, the contact discovered NHTSA Campaign Number: 26V290000(Power Train) and associated the failure with the recall. The failure reoccurred the next day; however, the vehicle failed to shift into drive(D). The vehicle was towed to the dealer. The contact notified the dealer of the failure and the recall; however, the dealer stated that the symptoms did not appear to be related to the recall. Two diagnostic tests were performed, and it was determined that the failure was not associated with the recall. The contact was texted a link that had a detailed list of the multiple issues with the vehicle; the contact was then given an estimate for the repair. The contact called several dealers about the failure, and the dealers agreed that, based on the symptoms described, the failure was associated with the recall. The contact attempted to make an appointment with other dealers; however, none was able to provide a loaner vehicle.

I am filing this safety complaint regarding my 2019 Jeep Cherokee Latitude Plus 2.4L AWD. This vehicle is experiencing severe, life-threatening safety hazards involving sudden engine stalling and a complete loss of motive power while in motion. Despite my vehicle exhibiting the exact failure symptoms of multiple major FCA/Stellantis safety recalls for this model year, my specific VIN is currently showing as excluded from the recall database, leaving me with a highly dangerous vehicle and no dealership remedy.The vehicle is suffering from two distinct, interrelated defects that have recently caused terrifying incidents in heavy traffic. First, while driving, the dashboard suddenly illuminated both the "SVC 4WD" (Service 4WD) and the "Auto Start-Stop" warning lights simultaneously. Immediately following these warnings, the vehicle lost forward power and unexpectedly rolled forward while I was fully stopped at a red light, failing to hold its position. This mirrors the exact mechanical behavior of the known Jeep PTU spline-wear defects that cause sudden rollaways and a loss of drive power.Second, the vehicle completely stalled out and shut down while I was driving on a highway exit ramp. The engine lost all power without warning, forcing me to coast through traffic, shift into park, and completely cycle the ignition to restart it. This engine shutdown creates an imminent risk of a rear-end collision on high-speed roads. The vehicle has a severe issue with oil consumption, which I suspect is dropping hydraulic pressure and forcing the engine to shut off while the car is shifted into drive.The manufacturer’s current recall parameters for the PTU failures and engine stalling issues on 2019 Cherokees are clearly too narrow. My vehicle is dealing with identical, dangerous safety failures as the units already recalled, but I am being denied a safe, free repair due to a VIN exclusion. I request that the NHTSA investigate this specific batch of 2019 VINs and force a recall.

Car started making a grinding noise with service 4 wheel drive lamp, aware of a recall stopped driving, towed to dealer. Found code C14A7-97 described in NHTSA Recall # 26V-290. Shift motor actuator replaced by dealership. Submission of receipts to FCA with their outrageous response of withholding reimbursement pending a remedy for the recall. Recall issued since May 2026.

The contact owns a 2019 Jeep Cherokee. The contact stated that the vehicle was repaired under NHTSA Campaign: 25V011000 (Power Train); however, the contact believed that the recall repair was insufficient. The contact stated that while driving approximately 35 MPH, the message "4WD – Service Required" was displayed. The vehicle was taken back to the same local dealer where it was diagnosed and DTC: C14A7-97 was retrieved. Upon further investigation, the contact associated the failure with TSB: 03-001-26: however, the VIN was not included. The manufacturer was made aware of the failure and a case was filed. The failure mileage was approximately 170,000.

I am reporting a severe cascading drivetrain failure on my 2019 Jeep Cherokee Trailhawk (VIN:[XXX] ) caused directly by defective components that are the subject of active federal safety recalls (NHTSA Campaigns 01C / 40D / 25V011).This vehicle has a documented service history of two separate, consecutive Power Transfer Unit (PTU) failures. The first PTU was replaced at a previous dealership, and a subsequent unit failed and was replaced later. The mechanical binding, slipping, and severe shock-loading caused by these factory-defective PTU modules repeatedly hammered the transmission's internal components during low-gear acceleration.As a direct result of this cumulative mechanical trauma, the transmission's 1st-gear clutch (Clutch A, a mechanical interlocking dog clutch) has prematurely failed at 80,500 miles, leaving the vehicle completely disabled and unable to safely engage forward gears. The dealership confirmed internal failure of the 1st-gear clutch but refused 100% repair coverage, stating the current PTU is functional. However, because this is a sealed ZF 9-speed transmission, the dealer cannot visually inspect Clutch A for cumulative metal fatigue or micro-fractures without a total teardown.The manufacturer, Stellantis/FCA, is refusing to take corporate responsibility for the cascading damage caused to the transmission by their recalled, defective transfer units (Corporate Case Number: XXX). I am requesting that NHTSA investigate how the structural defects in the 2019 Cherokee PTU systems are causing premature, catastrophic internal transmission failures in consumer vehicles INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I own a 2019 Jeep Cherokee (VIN [XXX]). While driving, the vehicle displayed a “Four-Wheel Drive Service Unavailable” / “Service 4WD” warning. I recently had the 4WD warning inspected by a service department via a transfer case actuator repair, but I was advised that the PTU showed signs of wear and may be developing an issue. I have also previously experienced a “Service Electronic Stability Control” warning and have had an ongoing vibration when braking. Approximately one year ago, the vehicle’s rear differential required a complete rebuild. I am concerned these issues may indicate a larger drivetrain/4WD system defect, particularly in light of NHTSA recalls **25V-011 (FCA 01C)** and **26V-290 (FCA 40D)** involving PTU/drivetrain concerns affecting Jeep Cherokees. My VIN does not currently show an open recall. I am requesting that NHTSA review whether these symptoms and the observed PTU wear may be related to the recalled condition or another known safety defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The component/system that is malfunctioning is the Power Transfer Unit. This is a well-known issue with Jeep Cherokees of many generations, including the 2019. It is available for inspection upon request, but it's being fixed at a Jeep dealership. No safety was put at risk, but if the PTU failed totally while driving, it would have put our safety for ourselves, and others ' safety at risk. This malfunction was confirmed/diagnosed at a dealership. The vehicle has not been inspected by the manufacturer, police, insurance representative, or anyone else outside of ourselves and mechanics. There was a warning light that would come on intermittently but wasn't constant with no other symptoms showing. This happened for less than a week before a thumping started and we were able to bring it in to a shop.

The motor experiences a malfunction, which the passengers feel as a slight ‘bump’ in the engine. The dash flashes Service Electronic Stability Control and the engine experiences a loss in power followed by a gain in power, experienced as slight lurching. The dash ESC icon lights up yellow simultaneously as the ESC button on the center dash instrument cluster. The vehicle continuously lurches as it tries to stabilize, at this point the most ginger touch to the accelerator is necessary, otherwise the engine may stall out. I have been left stalled in the middle of a road where there was moving traffic passing by both ways. The mechanic said the engine codes read- P0340- Camshaft Position Sensor B1S1 & U1428- Received Engine Torque request signal stuck.

The contact owns a 2019 Jeep Cherokee. The contact stated that while driving 30 MPH, the message “4WD-SVC” was displayed while leaving a veterinary appointment. The screen was turning on and off, and there was a dinging sound coming from the vehicle while the message was displayed. The vehicle was taken to an independent mechanic who was unable to assist. The vehicle was taken to the local dealer, where it was diagnosed with PTU failure. The contact associated the failure with NHTSA Campaign Number: 26V290000 (Power Train). The manufacturer was contacted and declined to help. The failure mileage was approximately 55,000.