Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2013 Toyota Camry HV — assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its 17-character VIN to decode that exact car — its engine, trim, assembly plant and factory equipment — alongside these records. Free, no account.
Run a VIN →Recalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Toyota Camry HV year.
No EPA fuel-economy match for this model (naming may differ or it predates EPA records).
3 open NHTSA investigations into this model. Investigations come before recalls, so these are potential defects not yet covered by one.
Rated configuration: 2013 Toyota Camry HV 4 DR FWD
The parts named most often across 295 owner complaintsfiled with NHTSA for this make, model and year — the closest free answer to “what is likely to go wrong?”
2 crashes · 1 injured
1 crash · 1 death
12 crashes · 11 injured
5 crashes · 3 injured
2 injured
7 crashes
1 crash · 1 injured
1 crash
Complaints are self-reported and skew toward problems people find alarming, so treat this as where to look, not a defect rate.
1 complaint-reported fatality on this model.
Shifting shudder
The contact owns a 2013 Toyota Camry. The contact stated while driving at an undisclosed speed, the transmission shuddered, with the check engine warning light illuminated. In addition, the contact became aware that the transmission was slipping. The vehicle was taken to an independent mechanic where it was diagnosed with transmission failure. The contact was informed that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 187,000.
Factory paint is peeling off. It is a known issue and Toyota won't do anything for me.
I attempted to open my car door and the door handle simply snapped off in my hand. This is the second time this has occurred. The first time, my driver's door handle snapped off when a technician at my Goodyear repair shop tried to open it. Now, the exact same thing happened to my passenger driver's side door when I went to open it. Upon closer inspection, it seems that the manufacturing is defective, as the handle seems to have been simply glued on in spots rather than more securely attached. Bear in mind that this car is barely driven more than twice a week; it barely has any wear and tear and is under 80,000 miles despite 12 years of use.
I have a vehicle in which a safety recall was issued for models In that body type and year range. The recall was issued in response to a software glitch that causes a shudder when acceleration. I called my local dealer and was told I do not qualify for a recall even though I have the exact same symptoms listed in the recall. I have spent over 3k trying to resolve this issue and have tried to reach out to corporate with no luck. My car is getting more unstable and nearly lost control due to the shudders. What can I do?
Car shudders at 40 to 50 mph recall previously on torque converter
The contact owns a 2013 Toyota Camry. The contact stated that while driving 40 MPH, the vehicle shuddered abnormally. There was no warning light illuminated. The vehicle was taken to the dealer where it was diagnosed as a failure with the torque converter. The torque converter was flushed, and it was stated by the dealer that the torque converter might have caused damages to the transmission and the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was approximately 205,000.
The contact owns a 2013 Toyota Camry. The contact stated while driving 15-20 MPH and depressing the accelerator pedal, the vehicle hesitated to respond. There was no warning light illuminated. The contact stated that the failure had been recurring increasingly while driving. The dealer and the manufacturer were not notified of the failure. The vehicle was not diagnosed or repaired. The contact related the failure to Toyota Campaign Number: ZE5. The failure mileage was approximately 90,000.
Unknown. The vehicle shutters tremendously while traveling between 40 and 60 mph.
Toyota Camry se 2013 When accelerating at a stop light or when slowing down to make a turn, it hesitates when stepping on it to go or when accelerating at a turn,. It will go about 5 - 10 feet and hesitate, It happens more several times in one day! It scares me and I’m worried about getting into an accident. No check engine light and does not throw any codes.
Hi. My name is [XXX] . I owe a 2013 Toyota Camry SE and the selt belts in the back are not working. That is a major safety issue. I need it to be fixed. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
My 2013 Camry shudders when I am accelerating, usually between 15-30 mph. It can be alarming since I expect the car to accelerate quickly but instead it shudders. I was making a right hand turn at a stop light, I went to accelerate and my car shuddered so badly and failed to accerelate so I was almost rear ended. This is a major safety concern when the gears do not properly change during operation. My local Toyota dealership diagnosed it as being a problem with the torque converter. I am aware that Toyota issued a Warranty Enhancement Notification - ZE5 to do three things, put in a new torque converter, additional transmission pan magnets, and update the software. I purchased my vehicle in 2019 and was not made aware of this by the Toyota dealership at the time of purchase nor did I receive anything in the mail. Now, Toyota refuses to correct this problem even though it continues to be an issue with owners of these vehicles.
Showing 12 of 295 complaints.
HTTP 400 Bad Request