2017 GMC Sierra 1500

The catastrophic power failure with no warning on my 2017 GMC Sierra, at 87450 miles completely contaminated the engine oil cooling lines with metallic debris and fractured structural mounts. The servicing dealership replaced the transmission but is refusing to remediate the engine line contamination without out-of pocket payment. The vehicle cannot be safely operated without causing terminal engine failure on the highway, creating a imminent mechanical and traffic safety hazard.

I had an engine rebuilt completed on my L86 2017 GMC 6.2. After the repair, the engine failed due to the crank shaft on the engine being oversized which is the same problem that GM is having with the L87 engines. When the crank was ordered from the dealer for my L86, the only part number for the crank that was available was the new part number that was being used in the L87. Seems the same cranks were used in both engines and this recall on the L87 should be extended to anyone that had a rebuilt complete. Me and my family were left on the side of the road for a few hours which endangered our lives. The problem was determined by an independent service center and was fixed by the purchase of new parts and aftermarket bearings for the crank to allow the oil to enter the crank properly. There were no warning signs. Was driving down the road, started to hear a noise and then the engine started to over heat so that is when I stopped and called a wrecker.

When I accelerate the vehicle, the gears shifts every 10mph when it shouldn’t. It does it all the way up to 60mph. It has been an on going problem since we got the truck

Truck was started using auto start and I drove roughly a mile down the road smelt burning and looked in the back seat, I saw smoke and promptly pulled to the side of the road shut the vehicle off then I heard a loud pop and saw the back drivers side window shattered.

Dear Sir, I currently own a 2017 GMC Denali that had a potentially catastrophic failure with one of the alloy wheels that are on my vehicle. Mileage about 110,000 I recently went to have new tires installed on my vehicles when the tire shop manager came from the work area and said that he could not put a new tire on my one wheels. The reason the tire store could not put a tire on that wheel is because two of the spokes on the alloy wheel were broken. There were three spokes between the broken spokes. The are 12 spokes on the wheel and the two broken spokes were non adjoining. They were not next to each other. There were good spokes between the broken spokes. With a close inspection of the wheel there is no scuffing or impact damage to the wheel either on the outside of the wheel or the inside that would cause this failure. The spokes just cracked. The fact that the two broken spokes are not next to each other would seem to indicate that this was a manufacturing defect. I am writing to go on record of this failure of the alloy wheel on my truck. If someone would like to inspect the wheel, please contact me to arrange for a time to look at it. I have attached pictures of the wheel with the broken spokes. Regards, [XXX] You can see the cracked spokes at the 12:00 and 7:00 position on the wheel towards the center of the wheel. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I drive this vehicle on higher speed roads to work everyday. Roads also used by large tractor trailers and like larger vehicles. I was told by dealer that I had broken exhaust manifold studs at a previous oil change. While driving the truck it seemed to lose power for a short time but I was in traffic and assumed the loss of power at that time was related to a possible exhaust leak.I scheduled a appointment to have the repairs addressed. When I picked up the vehicle I was told that there was a ticking noise in the top of the motor. They stated it was the lifters and needed to be repaired for $7136 dollars. I researched the problem and found out how big of an issue this is specifically for the owners of the 6.2l (L86) engine. Highly concerned I schedule the repair and dropped the vehicle off. Shortly after the dealer called and stated the vehicle had bent push rod collapsed lifters damage to the cylinder head, camshaft and worn camshaft bearings now cost are $14350 or replace engine for $17000. I chose to replace top end. The next day I was called back and was told the bearing on the cam journals were down to brass and I would need new engine. Cost in just 24 hours not are $22000. This vehicle was maintained by this dealer also for all fluid changes. The belief is all the failures were related to the active fuel management system. (going from 8 to 4 cylinders ).

The contact owns a 2017 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, there was an abnormal tapping sound coming from the vehicle. The check engine warning light and an unknown warning light were illuminated. The contact stated that the failure had occurred while traveling out of state. The dealer was made aware of the failure, and the contact was informed that the repair was not covered under recall. The vehicle was towed to an independent mechanic, where it was diagnosed with lifters failure. The contact was informed that the lifters and camshaft needed to be replaced. The contact was informed that the lifter's failure had damaged the camshaft. The vehicle was being repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 99,700.

The contact owns a 2017 GMC Sierra 2500 Denali. The contact stated that while driving at an undisclosed speed, the vehicle went into LIMP Mode. There was no warning light illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed and determined that the knock sensor had failed and needed to be replaced. The vehicle was not repaired. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 209,000.

The rear window on my 2017 GMC Sierra shattered unexpectedly without any impact. The vehicle had been remote started in very cold weather and the rear window glass suddenly shattered while the truck was parked. There was no rock strike or external damage that would explain the failure. I later learned about GM Customer Satisfaction Program N192265660 regarding rear window defroster thermal events affecting certain 2014–2019 GMC Sierra and Chevrolet Silverado trucks. Based on the sudden failure and the conditions at the time, this appears consistent with that issue. The Auto Rear Defog feature in the vehicle settings was turned off, however the truck had been started using the remote start feature when the glass shattered. Photos of the shattered window are available. I am submitting this report because the rear window defroster system may cause the glass to overheat and shatter unexpectedly.

Rear glass window shattered due to the defroster getting too hot. Some smoke was noticed

The contact owns a 2017 GMC Sierra Denali. The contact stated that while driving on the highway at an undisclosed speed, the vehicle jerked, failed to accelerate, and stalled. The vehicle was unable to shift into third gear. The check engine warning light was illuminated. The vehicle was drivable and was taken to the dealer. The vehicle was diagnosed with a wiring harness failure on the transmission. The vehicle was repaired based on the diagnostic test but failed to fix the vehicle. The vehicle was parked at the residence and was undrivable. The failure mileage was approximately 103,000.

The contact owns a 2017 GMC Sierra 1500. The contact stated that while attempting to start the vehicle, the defrost was turned on, but the defrost failed to function as intended. There was a loud pop, and there was brown and yellow smoke in the rear of the vehicle. The contact turned off the defroster. The vehicle was driven to the shoulder of the roadway. The contact exited the vehicle and inspected it. The contact stated that the rear driver's side sliding glass was fractured. The vehicle was not diagnosed or repaired by an independent mechanic or a dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 90,200.