Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2005 Jeep Wrangler, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Jeep Wrangler year.
No EPA fuel-economy match for this model. Naming may differ, or it predates EPA records.
NHTSA lists 2 recalls for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK.
Risk: LOSS OF BRAKE FLUID CAN LEAD TO A DECREASE IN BRAKE LINE PRESSURE AND AN INCREASE IN STOPPING DISTANCE, WHICH CAN RESULT IN A VEHICLE CRASH.
Remedy: AFFINIA (BRAKE PARTS, INC.) WILL REPLACE THE SUBJECT BRAKE HYDRAULIC MASTER CYLINDERS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2006. OWNERS CAN CONTACT AFFINA GROUP CUSTOMER SERVICE AT 1-800-323-0354.
Campaign 06E022000
Issue: ON CERTAIN PICKUP TRUCKS, SPORT UTILITY AND PASSENGER VEHICLES EQUIPPED WITH 42RLE AUTOMATIC TRANSMISSIONS, THE CUP PLUG THAT RETAINS THE PARK PAWL ANCHOR SHAFT MAY BE IMPROPERLY INSTALLED. IF THE SHAFT MOVES OUT OF POSITION, THE VEHICLE MAY NOT BE ABLE TO ACHIEVE 'PARK' POSITION.
Risk: IF THIS OCCURS AND THE PARKING BRAKE IS NOT APPLIED, THE VEHICLE MAY ROLL AWAY AND CAUSE A CRASH WITHOUT WARNING.
Remedy: DEALERS WILL INSPECT THE TRANSMISSIONS AND INSTALL A BRACKET TO ENSURE THE PARK PAWL ANCHOR SHAFT IS RETAINED IN THE PROPER POSITION. THE RECALL BEGAN ON NOVEMBER 28, 2005. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
Campaign 05V460000
NHTSA frontal crash test
Rated configuration: 2005 Jeep Wrangler 2-DR.
The parts named most often across 650 owner complaints filed with NHTSA for this make, model and year.
1 fire · 2 injured
2 injured
1 crash · 2 fires · 2 injured
1 crash · 1 injured
5 fires
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
2 complaint-reported fatalities on this model.
The contact owns a 2005 Jeep Wrangler. The contact stated that while driving 55 MPH, the vehicle stalled. The check engine warning light was flashing. The contact pulled over to the side of the road. The vehicle failed to restart and was towed to the residence. The vehicle was then towed to three different independent mechanics to be diagnosed, and the third mechanic diagnosed the vehicle with camshaft failure. The vehicle was not repaired. The dealer was contacted and referred the contact to the manufacturer. The manufacturer informed the contact that the vehicle was not covered under Chrysler Campaign Number: E05 due to the engine build date. The contact was referred to the NHTSA Hotline for assistance. The failure mileage was approximately 154,000.
Engine warning light has been coming on since about 70k miles(190k now). Scanner says O2 sensor is bad. After replacement of the O2 sensor, the fault continues to show up randomly. I carry a scanner to reset the engine code on the road. All wiring has been checked and is ok. When I clear the code, the error does not show up again for anywhere from 125 miles to around 300 miles. Clearing the code starts the process all over.
As I was driving home from work on Feb. 14, 2023, in Rocky Hill, NJ. the vehicle developed a sudden loss of steering control. I had it towed to Chrysler Dodge Jeep RAM of Princeton, NJ. The service manager informed me that the area of the frame to which the steering gear box is bolted had completely rotted, and the steering box had separated. The car was not driveable and could not be repaired. The vehicle will be available for inspection until April 15, 2023.
Ecm computer , o2 heater sensor from ecm and controls transmission shift points . Replaced o2 sensors and transmission is controlled by ecm not shifting correctly will stay in first gear and hard shift to second can create loss of control in wet weather conditions.
Keep wobble almost caused head on collision afraid to drive vehicle over 55 mph
The dashboard will display odd behavior and all of a sudden the ignition will cut. Total loss of power. This has happened in the past with children in the vehicle. Very dangerous. Resetting the key will reset but it is random.
The contact owns a 2005 Jeep Wrangler. The contact stated while driving approximately 65 mph, the vehicle loss motive power. Several gauges became inoperable with unknown warning lights illuminated. The contact pulled over and waited approximately 15 minutes before the vehicle was restarted. The vehicle was towed to the dealer but was not yet diagnosed or repaired. The ignition switch was replaced. The manufacturer was not made aware of the failure. The approximate failure mileage was 66,666.
Engine failed, speedometer, tach went to 0, all gauges went to 0, power steering failed after I declutched and then coasted to a full stop (power brakes failed but still had some brake input) safely on the shoulder of an off ramp. (This not the first time this has happened, however it was the first time pulling a full trailer, so I drive as if it could happen again) Vehicle was at Branhaven Jeep in Branford, CT last July @ 64429 miles... they were unable to duplicate. It is now at Gengras Jeep in East Hartford, CT, same story. I've asked Gengras to replace the ignition switch again. I have the ignition switch from Branhaven which I found the copper plate worn off to steel and evidence of arcing on the contacts
At every fuel fill up, gasoline splashes back out onto the vehicle, the person filling the vehicle and creates a very unsafe puddle of gasoline on the ground. There is never a time that it does not happen. I would be readily available to make my vehicle available for inspection of this concern. Chrysler has issued recalls for this exact problem on several of their vehicle models all within the same time period of manufacturing. The fuel tank inlet check valve is a widely known and dangerous issue that should be seriously considered to repair the remaining vehicles on the road with this problem. It has been documented by numerous owners of Jeep Wranglers from 2005-2006 while the same issue forced a recall of the same Jeeps in later model years, 2007-2008. The Jeep has been inspected by a certified mechanic where I was notified of much of this information. With the amount of gasoline that spills out and the motorist re-enters their vehicle, there could be a static charge that could ignite the gasoline and cause extreme personal harm and property damage. There is no indication or warning sign to alert you that it is going to splash out gasoline. I am left to rarely fill my fuel tank to the maximum level to avoid being soaked in gasoline and irritating my skin or worse. I have owned this Jeep for going on 4 years and it has been a concern since day 1. I am noting this report of having been injured but the injuries at this point are only skin irritations as a result of gasoline coming in contact with our skin. I also noted the date as the first time this happened but as mentioned before, it happens or will happen at every fill up.
The camshaft sensor upper bushing does not get lubricated seizes up causes camshaft to wear out. In my jeep I replaced three of them on the inline 4.0 6cyl. I only have 66,660 miles on my jeep. June 4, 2021.
ECU STOPED WORKING NO REASON.
THE PCM HAS A KNOWN HIGH FAILURE RATE DUE TO THE VIBRATION. THE COMPONENTS ARE COVERED IN A RESIN THAT YOU CAN NOT REMOVE. THE PCM IS 500-1300 TO GET A REPAIRED AND REPROGRAMED ONE. I HAVE A 2005 AND THE PCM HAS FAILED AND GIVES BAD PERFORMANCE AND DOES NOT RUN ON TEH 14.7 STOKES FOR AIR/FUEL/ IT DUMPS FUELS AND I DO NOT THINK IT MEETS EMISSON LEVELS IN THIS CONDITION.
Showing 12 of 650 complaints.