Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2010 Porsche 911 Carrera — assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its 17-character VIN to decode that exact car — its engine, trim, assembly plant and factory equipment — alongside these records. Free, no account.
Run a VIN →Recalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Porsche 911 Carrera year.
NHTSA lists 1 recall for this make/model/year. Recalls apply to the model, so some may already be fixed on this specific car — check with a dealer using the VIN.
Issue: Ohlins USA, Inc (Ohlins) is recalling certain Front Struts, part number POS 5N20. These struts were sold as part of Ohlins strut kits part number POZ MN02, intended for installation on 1999-2005 Porsche 911 Carrera 4 and 4S (generation 996), and 2001-2006 Porsche 911 Turbo / Turbo S (generation 996) and kit part number POZ MN05, intended for installation on 2005-2012 Porsche 911 Carrera 4 and 4S (generation 997), and 2006-2013 Porsche 911 Turbo / Turbo S (generation 997). The pin of the strut may experience excessive stress during maximum steering, possibly resulting breakage of the pin.
Risk: If the pin fails, it will cause separation of the strut from the vehicle, affecting vehicle control and increasing the risk of a crash.
Remedy: Ohlins will notify owners, and dealers will request the return of all unsold kits containing the subject part from dealer/distributor inventory for a full refund. All owners who purchased one of the kits (POZ MN02 or POZ MN05) will receive replacement front struts (POS 5N20 or POS 5N21 - These parts are interchangeable), along with new top mount interface solutions, free of charge. The recall began December 22, 2020. Owners may contact Ohlins customer service at 1-800-336-9029.
Campaign 20E091000
Rated configuration: 2010 Porsche 911 Carrera 2-DR w/SAB
The parts named most often across 1 owner complaintfiled with NHTSA for this make, model and year — the closest free answer to “what is likely to go wrong?”
Complaints are self-reported and skew toward problems people find alarming, so treat this as where to look, not a defect rate.
Last year my 2010 Porsche 911 GT3RS experienced a catastrophic engine failure while on the road. I had to shut off the car in the middle of a 4-lane highway and try to coast to a stop while navigating around much faster traffic risking my safety and the safety of other drivers. There was no warning prior to the failure. Just a sudden bang, followed by shaking and rattling noise. Once the car was towed to an automotive repair shop, the engine was taken apart and it was concluded that a piece from the intake broke off and got swallowed by the engine while on the road. I have images and documentation of the damage and the parts are available for inspection. The trouble is that the failed piece of the intake was part of a manufacturer recall to fix that exact issue back in 2013. After the findings of the repair shop I contacted Porsche Cars North America. The car was subsequently brought in to a Porsche dealer for inspection, where I was told multiple times that a failed recalled part would be covered by the manufacturer's good will repair policy. After 4 months of back and forth with the headquarters I was told that Porsche would not be responsible. I have spoken to other owners of this exact model cars and several of them have confirmed that their replacement intakes have failed, in some cases causing the engine to completely seize while on the road. Thankfully that did not happen to me.
Over 5 years this costs $6,250 more in fuel than an average new vehicle.