Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2013 Porsche 911 Turbo — assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its 17-character VIN to decode that exact car — its engine, trim, assembly plant and factory equipment — alongside these records. Free, no account.
Run a VIN →Recalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Porsche 911 Turbo year.
NHTSA lists 1 recall for this make/model/year. Recalls apply to the model, so some may already be fixed on this specific car — check with a dealer using the VIN.
Issue: Ohlins USA, Inc (Ohlins) is recalling certain Front Struts, part number POS 5N20. These struts were sold as part of Ohlins strut kits part number POZ MN02, intended for installation on 1999-2005 Porsche 911 Carrera 4 and 4S (generation 996), and 2001-2006 Porsche 911 Turbo / Turbo S (generation 996) and kit part number POZ MN05, intended for installation on 2005-2012 Porsche 911 Carrera 4 and 4S (generation 997), and 2006-2013 Porsche 911 Turbo / Turbo S (generation 997). The pin of the strut may experience excessive stress during maximum steering, possibly resulting breakage of the pin.
Risk: If the pin fails, it will cause separation of the strut from the vehicle, affecting vehicle control and increasing the risk of a crash.
Remedy: Ohlins will notify owners, and dealers will request the return of all unsold kits containing the subject part from dealer/distributor inventory for a full refund. All owners who purchased one of the kits (POZ MN02 or POZ MN05) will receive replacement front struts (POS 5N20 or POS 5N21 - These parts are interchangeable), along with new top mount interface solutions, free of charge. The recall began December 22, 2020. Owners may contact Ohlins customer service at 1-800-336-9029.
Campaign 20E091000
Rated configuration: 2013 Porsche 911 Turbo 2 DR AWD
The parts named most often across 6 owner complaintsfiled with NHTSA for this make, model and year — the closest free answer to “what is likely to go wrong?”
Complaints are self-reported and skew toward problems people find alarming, so treat this as where to look, not a defect rate.
Rear taillights can fall off the vehicle. This component is available for inspection and causes issues when other motorists are unable to see turn signals, brake lights, fog lights, and reverse lights. Mine fell off while driving on the highway and then through the city. There were no warning lights or indicating of the issue.
The door panels at the top wrap on my 2013 Porsche 911 and I understand this is a problem on Porsches 911 delivered between 2012 - 2019 A number of recommendations have been made for owners to glue the panel. This panel is designed to release in a side impact condition and any glue modifications to this panel would violate the designed operation. The manufacture is well aware of this issue and has replaced a number of them out of warranty for free, but you have to back them in a corner.
The taillamp housing failed, and taillamp fell out of the vehicle. Online research shows that this is a design defect that Porsche learned of early in the "991.1" generation cars, as it is reported by multiple owners at multiple sites online. Well, happened to my early 991.1 also. Porsche recognized the fatigue-failure within a year or so of launch, and instituted a fairly simple fix, by adding a metal reinforcement to the backside of the taillamp, to reinforce the insufficient plastic-only initial design. They launched this revised taillamp into 2014MY or early 2015MY cars (not sure when). No failures since. Porsche attempted to sweep this defect 'under the rug' by NOT recalling all earlier cars to institute a fix, but rather would just repair cars that failed under warranty. Porsche should not accept taillamps falling off of cars, especially at owners expense (and Porsche pricing!! Ouch). Please investigate.
The tail light assembly mounting fastener failed and the tail light assembly fell out of the rear bumper assembly. There was no indication of a failure while driving. Apparently this is a known issue with the 991.1 version of the 911. I’ve owned the car since new (MY 2013), have it serviced at a Porsche dealership and have not been notified of the potential safety issue.
I WAS PULLING INTO MY GARAGE AND NEARLY RAN OVER MY WIFE DUE TO THE GLARE ON THE WINDSHIELD . THIS CAR HAS A VERY LIGHT COLORED DASH TOP. THE GARAGE WAS SHADED BUT THIS WAS A BRIGHT SUNNY DAY.
AT HIGHWAY SPEED EXPERIENCED BRIEF, COMPLETE ENGINE FAILURE, THEN SIGNIFICANTLY REDUCED ENGINE POWER FOR THE REMAINDER OF THE DRIVE. THIS TYPE OF ENGINE FAILURE IN A MANUAL TRANSMISSION RESULTED IN RAPID DECELERATION. GIVEN THIS ENGINE BRAKING IS A RESULT OF ENGINE FAILURE, THE RAPID LOSS OF SPEED HAPPENS WITHOUT BRAKE LIGHTS ALERTING OTHER DRIVERS TO SPEED REDUCTION. TESTING INDICATED A FAILURE OF THE HIGH PRESSURE FUEL PUMP ACCORDING TO PORSCHE TECHNICIANS.
Over 5 years this costs $8,750 more in fuel than an average new vehicle.