Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2024 Toyota Crown — assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its 17-character VIN to decode that exact car — its engine, trim, assembly plant and factory equipment — alongside these records. Free, no account.
Run a VIN →Recalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Toyota Crown year.
No EPA fuel-economy match for this model (naming may differ or it predates EPA records).
NHTSA lists 3 recalls for this make/model/year. Recalls apply to the model, so some may already be fixed on this specific car — check with a dealer using the VIN.
Issue: Gulf States Toyota, Inc. (GST) is recalling certain Toyota 2023 GR Supra, 2024 4 Runner, Corolla, Grand Highlander, Grand Highlander Hybrid, Land Cruiser Hybrid, Tacoma, Tacoma Hybrid, 2023-2024 BZ4X, Corolla Cross Hybrid, GR Corolla, GR86, Highlander, Highlander Hybrid, Prius, Prius Prime, Sequoia Hybrid, Tundra, Tundra Hybrid, Venza Hybrid, 2023-2025 Crown, and 2025 Camry Hybrid vehicles equipped with GST accessories. The load carrying capacity modification label may display inaccurate added weight values. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims."
Risk: A vehicle with an incorrect maximum capacity weight value may be overloaded, which can increase the risk of a crash.
Remedy: GST will mail new labels to owners, free of charge. Owner notification letters were mailed September 16, 2024. Owners may contact GST customer service at 1-800-444-1074. GST's number for this recall is 24R2.
Campaign 24V548000
Issue: Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2023-2024 Toyota Venza, 2023-2025 RAV4 Prime, RAV4, Highlander, GR Corolla, Crown, 2024-2025 Lexus TX, LS, Toyota Tacoma, Grand Highlander, and 2025 Lexus RX, Toyota Crown Signia, Camry, RAV 4 Plug-in Hybrid (PHEV), and 4 Runner vehicles. Due to an error in the instrument panel software at vehicle startup, the instrument panel may fail to display vehicle speed, brake system, and tire pressure warning lights.
Risk: An instrument panel display that does not show critical information can increase the risk of a crash or injury.
Remedy: Dealers will update the instrument panel software over-the-air (OTA) for non-PHEV vehicles, free of charge. For PHEV vehicles, dealers will inspect the instrument panel assembly, and either replace it, or update the software, free of charge. Owner letters were mailed December 5, 2025. Additional letters will be sent, anticipated in May 2026. This is a phased recall. Owners may contact Toyota's customer service at 1-800-331-4331. Toyota's numbers for this recall are 25TB08 and 25TA08. Lexus' numbers for this recall are 25LB05 and 25LA05.
Campaign 25V595000
Issue: Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2022-2026 Toyota, Lexus, and Subaru Solterra vehicles equipped with a Panoramic View Monitor (PVM) system. Please see the recall report for a complete list of models. A software error may cause the rearview camera to freeze or display a blank screen when the vehicle is in reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
Risk: A rearview camera that fails to display an image can reduce the driver's view behind the vehicle, increasing the risk of a crash.
Remedy: Dealers will update the parking assist software, free of charge. Owner letters were mailed January 2, 2026. Owners may contact Toyota's customer service at 1-800-331-4331. Toyota's numbers for this recall are 25TB13 and 25LB06. Subaru's number for this recall is WRE25.
Campaign 25V744000
NHTSA has no NCAP crash-test rating for this model/year (common for older, low-volume, or heavy-duty vehicles).
The parts named most often across 17 owner complaintsfiled with NHTSA for this make, model and year — the closest free answer to “what is likely to go wrong?”
1 crash
Complaints are self-reported and skew toward problems people find alarming, so treat this as where to look, not a defect rate.
When vehicles comes to a stop, sometimes there is a hesitation in vehicle acceleration. Vehicle will jerk, then accelerate 3-4 seconds after pressing down throttle. Car does not provide or show error codes. There is currently a Toyota Service Bulletin for the exact same issue for the Toyota highlander (TSB-0017-24) which address the issue "Hesitation felt while accelerating at low speeds." And the fix involves a software update for the engine control unit. Since there is no official documentation for the Toyota crown platinum which shares the same engine configuration, Toyota refuses to provide a resolution. This puts vehicles occupants at risk of a crash, as if you are expecting to accelerate and the vehicle refuses, another driver might not anticipate this and put you at risk of a crash due to the inability to accelerate properly and safely.
Our 2024 Toyota Crown Platinum has been experiencing random loss of power or torque when merging into traffic from a complete stop. The vehicle will be working fine; then, while attempting to accelerate from a complete stop, there is no torque or ability to accelerate up to posted speed. Not sure if it is an engine or transmission issue…but it represents a significant safety concern when it happens if pulling out from a stop to merge into oncoming traffic. The driver of the vehicle judges if it is safe to make a right turn on red (for example) and when the car does not perform as expected and there is a loss of torque or acceleration, this creates an opportunity for other drivers to rear end you as your vehicle is moving at a very slow rate of speed and not accelerating to appropriate traffic conditions.
Hood prop rod comes loose from hood when tying to lift hood slightly so I can close it.
2024 Crown Hybrid system keeps popping up on dash saying warm lamp came on twice: third time Warning lamp turned. Vehicle has been serviced twice at same dealer and then taken to another for same problem. The problem has not been resolved. Dealership indicates cannot duplicate problem. I have even shown the dealership from photo and not able to resolve.
The main instrument panel on numerous occasions remains locked on “Experience Drive Connect”, usually when starting the vehicles, but occasionally when the vehicle is being driven. Sometimes when we can turn off the car and restart, the screen will begin normal functions. Yesterday the screen remained locked after 5 shut-downs and we had to drive with a locked screen. This causes the loss of some critical functions. The fact that there remains no remedy places drivers at greater risk and should not be acceptable to the FTC nor affected Toyota drivers. We should not have to trade a higher end 2024 vehicle with 10K miles for another brand to remedy this issue. Additionally, the vehicle may lose trade value with a pending recall that prevents dealers from certifying the auto.
I was backing up the vehicle into a driveway and then again the screen went blank and no back up lights as well. This vehicle had just been back from the dealer and they had requested photos which I did immediately and back to the dealer for about the 6th time for the same issue.
With "hold" feature engaged after 3 to 4 minutes car moved forward ON IT's own and main panel displayed EPS TURNED on. this happened 4 times in about 15 minutes. AFTER I had car in the dealership THAT DAY.
I had Hold feature engaged during a I-70 construction traffic stop. after 7 or 8 minutes auto rolled forward by it's self and something like eps turned on. I was floored at this hazzard and it could have killed someone, if they were infront of my auto.
Intermittently as I press on the brake, the engine loses power, engine feels like it is going to die and the charge meter on the dash display drops to no charge. Right before the engine dies the engine regains charge on the dash display charge meter and the engine returns to normal. So far the engine has never totally died on me yet.
The contact owns a 2024 Toyota Crown. The contact stated that while attempting to accelerate from a stop, the vehicle hesitated while accelerating. There was no warning light illuminated. The vehicle was taken to a local dealer where the vehicle was diagnosed, and the contact was informed that no cause for the failure was found with the vehicle. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 7,000.
When starting into traffic from a dead stop - stop sign, merging, traffic light - the car hesitates acceleration. It stumbles and shudders like it has run out of gas for h n it has not. This puts me in danger when pulling out into traffic since the car does not take off properly. The car has 16,151 miles on it and this issue has begun within the last 60 days. It has had no previous problems. I have not yet taken it to a dealer. There are no warning lights lit wh n this happens. The date below is the most recent.
2024 Crown Platinum 5k miles. This incident has happened several times. The car will completely stall out, have no power, won’t move. It’s random at times and other times it after a stop sign, yield, or slow down in speed. When you go to give it gas you have to stick the gas pedal to the floor and pray it will go. It always comes out of it, but takes a few seconds to get it together. It’s like it doesn’t know what mode it’s in- hybrid or power, so it sits and thinks about it. This could be deadly in the right situation.
Showing 12 of 17 complaints.