Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2016 BMW Z4 — assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its 17-character VIN to decode that exact car — its engine, trim, assembly plant and factory equipment — alongside these records. Free, no account.
Run a VIN →Recalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every BMW Z4 year.
No EPA fuel-economy match for this model (naming may differ or it predates EPA records).
NHTSA lists 1 recall for this make/model/year. Recalls apply to the model, so some may already be fixed on this specific car — check with a dealer using the VIN.
Issue: BMW of North America, LLC. (BMW) is recalling certain 2012-2015 X1 sDrive28i, X1 xDrive28i, 2012-2016 Z4 sDrive28i, 528i, 528i xDrive, 328i, 328xi, 2016-2018 X5 xdrive 40e, 2014-2016 228i, 228xi, 428i, 428i xDrive, 328xi Gran Turismo, 2013-2017 X3 sDrive28i, X3 xDrive28i, 2015-2018 X4 xDrive28i, 2015-2016 428xi vehicles. An improperly sealed electrical connector on the water pump may be exposed to water and short circuit.
Risk: An electrical short increases the risk of a fire.
Remedy: Dealers will inspect and replace the water pump and plug connector as necessary, and install a protective shield, free of charge. Owner notification letters were mailed on March 28, 2025. Owners may contact BMW customer service at 1-800-525-7417.
Campaign 24V608000
Rated configuration: 2016 BMW Z4 C RWD
The parts named most often across 4 owner complaintsfiled with NHTSA for this make, model and year — the closest free answer to “what is likely to go wrong?”
1 crash · 1 injured
Complaints are self-reported and skew toward problems people find alarming, so treat this as where to look, not a defect rate.
The contact owns a 2016 BMW Z4. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The air conditioning system has a very very foul musty smell when you first start the vehicle after sitting for a few hours. It will go away after a few minutes, but the dealer nor repair shops can fix the issue. System was cleaned, new micro air filter was installed, but still have the musty odor. Even the a/c drain was cleaned, all to no avail. This seems to be a class thing with all BMW vehicles according to the many BMW owners I have spoken with. But no one can fix the problem.
TL* THE CONTACT OWNS A 2016 BMW Z4. THE CONTACT STATED THAT WHILE HIS WIFE WAS STOPPED AND THE BRAKE PEDAL WAS DEPRESSED AN UNKNOWN NOISE WAS HEARD AS, THE VEHICLE ACCELERATED OUT OF CONTROL AND CRASHED INTO THE REAR OF THE VEHICLE IN FRONT CAUSING THAT VEHICLE TO CRASHED INTO THE VEHICLE AHEAD OF IT. THERE WERE NO WARNING LIGHTS ILLUMINATED. THE DRIVER'S SIDE FRONTAL AND KNEE AIR BAGS DEPLOYED. THE DRIVER SUSTAINED MINOR INJURY THAT REQUIRED MEDICAL ATTENTION. A POLICE REPORT WAS FILED. THE VEHICLE WAS TOWED TO AN AUTO BODY REPAIR FACILITY. THE CONTACT CALLED THE BMW OF TEMPLE DEALER (6006 S GENERAL BRUCE DR, TEMPLE, TX 76502) AND WAS TOLD TO CALL THE MANUFACTURER. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE AS THE CONTACT WAS AWAITING THE REPORT FROM THE EVENT DATA RECORDER (EDR) AND A CASE WAS OPENED. THE CONTACT WAS CONCERNED AS HE WANTED THE CAUSE OF THE FAILURE TO BE DIAGNOSED BEFORE THE VEHICLE WAS RETURNED TO HM. THE FAILURE MILEAGE WAS APPROXIMATELY 8,000. THE VIN WAS NOT AVAILABLE.
ABOUT 20% OF TIME, DRIVER SIDE SEAT BELT JAMS, WILL NOT RELEASE FROM RECESS/RETAINER BEHIND SEAT WITHOUT USING MY HAND FOR COUPLE MINUTES TO JIGGLE ENOUGH. NO PROBLEM ONCE I GET IT TO RELEASE. THEN FITS IN CONNECTOR AND ALSO RELEASES OK. TWO LOCAL DEALERS UNABLE TO FIX. ONE EVEN REPLACED ENTIRE MECHANISM, STILL JAMS. MANAGER SAID THIS MODEL SEEMS TO HAVE THIS PROBLEM. THIS OCCURS AT A STAND STILL, BEFORE PUTTING CAR IN GEAR, SOMETIMES WITH MOTOR ON, SOMETIME BEFORE I START THE ENGINE. SOMETIMES JUST OPENING THE DOOR CAUSES THE RELEASE. OTHER TIMES, I HAVE TO PUT MY HAND UNDER THE BELT AND MANEUVER THE BELT UNTIL IT RELATES FROM THE RETAINER INTO WHICH THE BELT RETRACTS. NO PICTURES INCLUDED. JUST A STANDARD SEAT BELT. HAD A BMW 3351 FOR 7 YEARS. NEVER HAD THIS PROBLEM ONCE.