Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2007 Mini Cooper, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Mini Cooper year.
NHTSA lists 1 recall for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: BMW of North America, LLC (BMW) is recalling certain 2008-2014 MINI Clubman Cooper, Clubman Cooper S, Clubman John Cooper Works, and 2007-2013 MINI Hardtop 2-Door Cooper, Cooper S, and John Cooper Works vehicles sold, or ever registered, in Alaska, Colorado, Connecticut, Delaware, Illinois, Indiana, Iowa, Kansas, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, Nebraska, New Hampshire, New Jersey, New York, North Dakota, Ohio, Pennsylvania, Rhode Island, South Dakota, Utah, Vermont, Virginia, West Virginia, Washington D.C., and Wisconsin. The electronic control module in the driver's side footwell area may short-circuit, due to corrosion from water and road salt.
Risk: An electrical short-circuit can increase the risk of a fire.
Remedy: Dealers will inspect the sunroof drains, interior footwell area, and FRM and, depending upon the results of the inspection, certain components will be replaced. Owner notification letters were mailed May 13, 2024. Owners may contact BMW customer service at 1-866-825-1525.
Campaign 23V337000
31.7 mpg average · 27–36 range · EPA says 29
Over 5 years this costs $2,250 more in fuel than an average new vehicle.
1 open NHTSA investigation into this model. Investigations come before recalls, so these are potential defects not yet covered by one.
Rated configuration: 2007 MINI Cooper Convertible w/SAB
The parts named most often across 384 owner complaints filed with NHTSA for this make, model and year.
6 fires
3 fires · 15 injured
4 crashes · 2 injured
7 fires
1 fire
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
An authorized manufacturer dealership performed an official safety recall remedy regarding the Footwell Module (FRM) under Campaign 610523 (Repair Order #922462) on a 2007 Mini Cooper. The vehicle was subsequently returned to the consumer in a completely non-compliant, unroadworthy, and highly hazardous condition with primary vehicle electronics and safety lighting disabled. Specifically, the low-beam headlights, passenger-side high-beam headlight, all rear tail lights, and the vehicle's electrical sunroof system are entirely non-functional, leaving only a single driver-side high-beam operational. The technician’s service invoices explicitly document a control module programming failure that was bypassed without verifying physical lighting or electronic circuit operations. Due to an administrative records error by the service center, the facility contacted local law enforcement to execute an unannounced welfare check at the consumer's secure residence, actively disrupting a highly sensitive personal safety perimeter involving a domestic violence restraining order. Following the forced immediate pickup of the vehicle, the consumer was subjected to a highly dangerous, 130-mile interstate drive entirely after dark with zero operational front or rear outline safety illumination, creating an extreme and life-threatening physical hazard to the vehicle occupants and surrounding traffic. The service facility has failed to provide a functional or compliant recall remedy and closed out the safety recall electronically despite the critical safety components remaining disabled.
I recently purchased a used MINI Cooper with incomplete NHTSA Safety Recall 23V-337 involving the Footwell Control Module (FRM). The previous owner did not complete the recall remedy. The vehicle's turn signals and brake lights are currently inoperative. The FRM controls various vehicle lighting functions and is the component involved in Recall 23V-337. Because I purchased the vehicle with these conditions already present, I do not know what warning lamps, messages, or symptoms occurred before the failures. The loss of both turn signals and brake lights creates a significant safety risk because other motorists cannot be properly notified when the vehicle is turning, changing lanes, slowing, or stopping. Additionally, Recall 23V-337 states that corrosion of the FRM can potentially result in a short circuit and, in rare cases, a thermal event that could increase the risk of injury. The vehicle has not yet been inspected to determine whether the current lighting failures are directly caused by the recalled FRM, but the recall remains incomplete and the vehicle is available for inspection. I contacted BMW/MINI seeking completion of the recall. I was informed that it must be performed by an authorized MINI dealer. There is no authorized MINI dealer in Montana, and the nearest facility is approximately 500 miles away. BMW/MINI declined transportation assistance, mobile repair, or authorization for a closer BMW dealer or qualified repair facility. Although the vehicle can move under its own power, driving approximately 500 miles without brake lights or turn signals, while it also has an outstanding recall involving a potential electrical short circuit and thermal event, presents a serious safety concern. I am actively attempting to complete the recall and am requesting NHTSA review the safety issue and BMW/MINI's lack of a practical means for safely accessing the recall remedy.
What happened: Vehicle has experienced failure of the Footwell Control Module (FRM) and associated wiring harness in the driver footwell area, consistent with NHTSA Recall 23V-337. Symptoms: • Exterior lights (headlights / taillights) remain illuminated far longer than normal after vehicle shutoff, sometimes not turning off at all. • Inspection revealed melted wiring, melted connector plugs and receptacles for headlight/taillight circuits. • Water was found in driver side footwell in the past / under carpet padding. Carpet pad is saturated. This is the same failure mode described in Recall 23V-337: "Due to a number of contributing factors, over time, the FRM could become susceptible to corrosion. Eventually, the corrosion could potentially result in a short circuit, resulting in a potential thermal event which could increase the risk of a fire or injury." Safety risk: Melted wiring and connectors create short circuit and thermal event risk, including fire risk while vehicle is parked and unattended. Lights failing to shut off creates dead battery / loss of exterior lighting control. I am concerned about vehicle fire. My vehicle shows evidence of having caught fire at the headlight and receptacle point. Recall history: Vehicle is included in NHTSA Campaign 23V-337000 (MINI Recall 23V-337 - Footwell Module Moisture/Water Intrusion). I was told remedy is still being developed / parts unavailable, or that additional wiring harness damage beyond the FRM itself is not fully covered. Dealer has inspected the vehicle and has completely disregarded the recall, which was the reason why I brought it in and have quoted me customer pay estimates for repairs covered under the recall. I am filing this to document that Recall 23V-337 failure has resulted in melted wiring harness components beyond just the FRM module, and to request NHTSA evaluate whether the current recall remedy fully addresses wiring harness damage caused by prolonged FRM corrosion / lights staying on.
The authorized dealer performed a non-compliant remedy for Safety Recall 23V-337. The initial repair resulted in melted wires and a charred connector due to high resistance. The dealer's subsequent re-repair utilized an un-staggered cluster of approximately 8 inline crimp connectors in a single tight bundle.This directly violates BMW Factory Repair Standard ISTA/AIR 61 13, which explicitly mandates: 'Arrange individual interfaces in an offset manner when repairing multiple cables. The wiring harness thus does not become too thick at the repaired point.' By failing to offset the splices, the dealership created a thick, bunched thermal mass that traps heat and strains the circuits, leaving an active passenger cabin fire hazard intact. Delivery has been officially refused
The contact owns a 2007 Mini Cooper. The contact stated that while driving at an undisclosed speed, the engine seized. No warning lights were illuminated. The vehicle was towed to the residence. The contact, who was an independent mechanic, researched and diagnosed the failure with water damage to the junction box electronics. The manufacturer was made aware of the failure but provided no assistance. The contact referenced an unknown recall that had a similar failure description; however, the VIN was not under recall. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 116,000.
The contact owns a 2007 Mini Cooper S. The contact stated that water was entering the vehicle through the sunroof. The contact stated that the water was collecting inside the headliner and would overflow and leak down the driver’s and passenger’s side sun visors and into the electronics of the footwell. Additionally, the front driver’s and passenger’s seats, floorboards, and dashboard would become soaked from moisture. Due to the failure, the vehicle would fail to start or operate as needed. Upon investigation, the contact discovered NHTSA Campaign Number: 23V337000 (Electrical System); however, the VIN was not included in the recall. An independent mechanic was notified about the failure and the contact was advised to park the vehicle outside as the failure could cause the vehicle to catch on fire. The manufacturer was then notified of the failure and the contact was referred to the NHTSA Hotline to report the failure. The vehicle was not repaired. The failure mileage was approximately 140,000.
The airbag warning light randomly remains on. From what I understand this is a known issue as there has been previous recalls by Mini. This could potentially mean the airbag system is faulty and non-operational. Based on online searches, it seems like a lot of there problem are wiring problems though, bad connections. The previous recalls should be extended further, as there are other cars with the same problem, like mine.
The contact owns a 2007 Mini Cooper S. The contact received notification of NHTSA Campaign Number: 23V337000 (Electrical System); however, the part to do the recall repair was not yet available. The contact stated that while the vehicle was parked, the sunroof was inoperative. The contact waited for several minutes for the sunroof to return to normal operation. The "Passenger Air Bag Disabled" message was displayed on the instrument panel; however, the passenger’s seat was occupied. The infotainment system was unintentionally turned on while the vehicle was turned off. The check engine and low tire pressure warning light were intermittently illuminated. The failures occurred on several different occasions. The contact stated that there was no local dealer; a dealer was not contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. Parts distribution disconnect.
On almost all r56 model mini coopers the passenger seat occupancy sensor has a major malfunction that causes it to fail and pop up an airbag sensor light even when someone is sitting in the seat, Mini USA did not issue a recall but rather a reimbursement form for owners in 2017 the last year of production for that car and did not publicly disclose this. I feel as though this should be a recall as it is common enough for bypass devices to be normal for this car
[XXX]. Mini Cooper 2007-2013: Recalls and TSB. My car is part of a recall under MINI Recall for Timing Chains. I understand now it was settled as part of a class action lawsuit that extended the warranty. I always take my car to a dealer and now after mileage they told me that they want me to pay out of my pocket. My car is a 2007 S. My mileage is 105,000K miles. The recall notice is for the year of my car and they are saying my car is too old and the mileage. This recall is for the year of my car so I am not understanding. Upon inspection by the dealer, it and needs to be replaced and cost $4,100.00. I don't have that kind of money. . My name is [XXX], [XXX]., [XXX], [XXX]. Phone #[XXX]. The dealership is Mini Cooper 1660 E.Spring Street, Long Beach Ca 90806. I never received this recall notice and knew of this only because I took my car to the dealer for something else related for the 3rd time.
The contact owns a 2007 Mini Cooper. The contact received notification of NHTSA Campaign Number: 23V337000 (Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated the key fob failed to lock and unlock the vehicle, causing the contact to manually lock and unlock the vehicle. The contact also stated that the radio would change stations or power off independently. The vehicle had been taken to an electrician who referred the contact to the dealer. The dealer was contacted. The manufacturer was made aware of the failure. The failure mileage was 153,000. VIN tool confirms parts not available.
The open recall for this vehicle has been open for 15 months now. Meanwhile my wife's car remains broken down with a bad footwell module due to the exact reason the recall is being issued. I contacted mini and they said I'd have to pay for repairs out of pocket and apply for reimbursement after they come up with a remedy. I have issues with this for a few reasons. First, the repair is costly. Second, it's already been over a year since the recall has been issued, and still no remedy so who knows when they'll actually have one. Third, they said that even if I pay for repairs out of pocket there's no guarantee I'd get reimbursed for them. In my opinion, for something as serious as this recall, the manufacturer should be on the clock to determine the remedy and repair customers cars. It would be nice if BMW/Mini would get some pressure to get this resolved so the my wife and the thousands of other people affected by this can enjoy the vehicles they spent their hard earned money on without worry that it might spontaneously burst into flames.
Showing 12 of 384 complaints.